 At the missions begining either on the runway or on the air, your cockpit view is same as picture shown above... Of course, if you did not set another cockpit view... |
 Now, to see both the ground and the air radar screens located at the left side, also the altitude dial and the all info about the aircraft located at the right side, pres 
|
 First, we have to activate the both ground and air radars by pressing  As a result, at the HUD "B" is changed by "R"... |
 Then, we have to set the targetting mode for ground and air radars as "Target enemies only"... It is very important... Double pressing... 
|
 You can remove these type of messages by clicking 
|
 Now, we have to set the throttle 100 to activate the after burner... After this operation we will be ready to gain speed... Pres  "T 0" located at the most upper left side of the HUD is changed by "T 100"... |
 We are ready to gain speed for take off... But, we have to set the wheel brakes off... If you do not this rapidly, your aircraft may be damaged... Pres  "W" located at the most upper right side of the HUD is disappeared... And you will start to gain speed... See the increasing air speed indicator... |
 Now, it is time to take off... Control the air speed indicator carefully... When you reach 120 - 140 knts, you may take off by pushing 
|
 You may close the landing gear by pressing  But, be carefull that your altitude indicator must show the minimum value of "200", preferably "300"... "G" located at the most upper right side of the HUD is disappeared... |
 You are on the air... Have a good flight... |
 During the missions, you have to land on some short airways for refueling and rearming, obligatorily... At this situation, of course, after your aircraft is stopped, you will have a short distance to take off again... To take off rapidly, set the after burner stage "4" by pressing  At the emergency conditions, try to take off when your aircraft's speed reaches 70 - 80 knts by pushing
|
 After you take off safely, decrease the after burner stage "0" (throttle "100") by pressing 
|